Polymer Flat-Faced Forward Set Trigger Kit for M&P M2.0

Polymer Flat-Faced Forward Set Trigger Kit for M&P M2.0

Apex Grade 9mm Gunsmith Fit Threaded Barrels for M&P

Apex Grade 9mm Gunsmith Fit Threaded Barrels for M&P

Apex Grade 9mm Gunsmith Fit Barrels for M&P

As low as $200.00
Availability: In stock
Only %1 left
SKU
105-050-C
Add to Wish List

Details

Sub-one-inch groups at 25 yards? Yes. The Apex Grade Gunsmith Fit Barrels set the standard for accuracy. When properly fitted to both the slide and the frame of the pistol, these barrels can deliver 1.00” – and under – 5-shot groups at 25 yards, assuming you do your part. These barrels feature a 1:10” twist rate along with Apex’s proprietary, patented locking geometry.

- These barrels require fitting

 

Conversion barrels:

All of the above listed barrels may be used as "Caliber Conversion" barrels for the M&P & M2.0 chambered in 40S&W and .357SIG.  Meaning, fitting the appropriate length Apex 9mm Gunsmith Fit barrel into your 40S&W or .357Sig M&P or M2.0 will allow you to shoot 9mm from your pistol.  You will need to use a 9mm magazine with this barrel for proper function.

We strongly recommend using these barrels in a "Conversion Barrel" capacity for training and/or practice use only.  If you're going to trust your life to your pistol, you really should purchase it in the caliber you plan to use it in.

 

Barrel Hood Side Gap: When our 9mm barrel is installed into a 40S&W or .357Sig slide, you will notice a gap on either side of the barrel hood.  This gap is normal and has no bearing on the accuracy of our barrels.

 

Extractors: If you choose to use our barrel as a "Conversion Barrel" and you experience extraction or feeding issues, we recommend you remove the extractor and clean the hook out thoroughly and the inside of the slide.  You should also consider an Apex Failure Resistant Extractor for your M&P or M2.0.

 

Recoil Assembly: When using these barrels as a "Conversion Barrel", we recommend using a factory recoil assembly appropriate for the caliber which matches your barrel.


For Use In These Guns

Part #105-045 works in the M2.0 Compact 9mm pistols with a factory 3.6" barrel.  Also works in Classic M&P Compact models 9mm pistols with a factory 3.5" barrel. The barrel does stick out of the Classic Compact slide a bit more than on the M2.0C slide.

Part #105-048 works in the M2.0 Compact 9mm pistols with a factory 4" barrel.

Part #105-050 works in all M&P and M2.0 9mm pistols with a factory 5.0" barrel.

Part #105-051 works in all M&P and M2.0 9mm pistols with a factory 4.25" barrel.

 

Does Not Fit These Guns

Not for use in Shield or SD model pistols

What's Included

1 ea. Apex Grade Gunsmith Fit Barrel

Installation Resources

Products to Consider